manual89

Coffee is for deserters?

McAfee can't hold a candle to this man.

While you would get a nice static balance that way, hanging heavy weights far from the center of a sports car would likely destroy its charm.

I'd like to know how long it would take to print a benchy using this technique.

Too bad the plate cost data wasn't presented. Was wondering which was the most expensive. In Oregon the cost varies pretty wildly, and some don't have a renewal surcharge.

They come halfway close, but not enough pressure in the end.

They are also not going to last you very long especially if you use it a lot.

Q2 explosions were actual meshes which I thought was rather unique.

Back in the day I came across a PC port of Mortal Kombat II. The box had a label specifically stating that it would not run on the AMD CPUs of its day...

Honestly even their mid grade and above power tools are decent. I have an earthquake xt electric impact that makes short work of suspension and lug nuts.

All good except for the inevitable 30% ADM on cars like that.

I was sort of hoping these would be SVG files based on their style. Impressive illustrations.

When I was flying out of Narita Airport, the vending machines within were the exact same prices as those on any street corner in Japan: very reasonable.

If you're in the US, printed solid is basically prusa's US arm now and carry a majority of their parts.

Good neck workout too.