jerryr

Please create or point me to your product review site!

There are a lot of things I don't miss! x86 segmented architecture, for example. Even modern embedded programming on an ARM Cortex-M feels luxurious compared to not that long ago.

If you enjoyed this article, you might also enjoy The Man Who Mistook His Wife for a Hat and Other Clinical Tales by Oliver Sacks. It’s a book of essays about brain function and disorders, but each begins with an individual who exhibits particularly unusual symptoms. They don’t have tidy resolutions like this article, but the book is well-written and engaging—-as are the rest of Dr. Sack’s writings.

Not that they can’t also be contributing to Bazel, but I believe that Chrome uses GN.

It was also for a low-cost audio application, but it wasn't a toy. This was back in 2001 or so. The MCUs in this article all only have ~1KB ROM, which wouldn't have been enough for our audio samples. We needed >256KB. The "4-bitness" was just incidentally what Winbond offered with a large ROM at the time. However, the SunPlus that we later used in the toy also offered a large ROM with an 8-bit CPU for a similar cost. So, while I can't authoritatively say that 4-bit is dead, it does seem like there are a lot of alternatives in similar price ranges now.

That sounds very similar to my experience with toy development. For a toy that played a bunch of pre-recorded sounds, we used a 4-bit Winbond MCU (their MCU division is now Nuvoton) that had a tiny bit of RAM and a ton of mask ROM. Firmware development was done in assembly and targeted a huge (physically large) emulator for test/debug. When we were satisfied with the firmware, we'd send it off to our CM, who would then order the parts with our FW in ROM. They'd get back bare die parts, which were wire bonded to the PCB and then epoxied over (that miserable "glop top" packaging, which is the bane of many teardowns). Development was a bit painful, but high volume production was extremely cheap.

Edit: Oops. I conflated projects. The toy project actually used a SunPlus MCU, not a Winbond MCU. It was an 8-bit RISC CPU running at 5MHz with 128 bytes RAM and 256KB mask ROM. The ROM held both the program and audio samples. I don't recall what encoding was used for the audio.

This is a friend’s project. It’s a public domain, header-only vsnprintf that supports floats. It has zero dependencies, zero libc calls, no allocations, < 100B stack, < 5K on a Cortex-M with optimizations on. It’s meant for small systems where you need a full-featured printf without a huge footprint.