doug_life

This printer at least comes with the "Open Material Mode (included)" that lets you print with 3rd party resins. I'm sure the workflow won't be quite as nice as with the Formlabs native resin. That is unless you can somehow refill the old jugs or buy empty ones. Before long I imagine 3rd party compatible containers will show up.

Agreed, unless you need to print intricate 3D figurines or high resolution engineering widgets, get a FDM printer and avoid the mess of SLA.

You can wash manually with some isopropyl alcohol in a wash basin and then cure in the sun. It will be a pain to do, and somewhat inconsistent, but its possible. You can also get a cheaper wash and cure station for other 3D printers that would likely work well enough with some tuning.

Thanks. I’ve been looking for a clean ots solution and somehow managed to not come across your company yet. Just purchased pre-assembled module!

Note this is from 2017

Note this is from 2016

It is likely that that the sub had it's antenna tuned to work well in water while the RC car antenna was tuned for open air. The two different mediums will change the antenna impedance.

Any idea why this would not be compatible with Vivaldi 7.5.3735.66? The store says "This item is not compatible with your current Chrome version"

Should we also stop adding iodide to salt or fortifying white bread? I see your point, but society has benefited as a whole by forcing some of these substances onto populations. I think it's fairly evident that many humans in the US are either unable or unwilling to really care about their health.

This may be obvious to most here, but you need Node.js installed for the MCP server to run. This critical detail is not in the set up instructions.

Side note, I really wish software would stop using EE terminology to name things. Ohm, Capacitor, Electron, etc. It muddies up search results for no good reason. Is there a reason this has become a trend lately?