awayenberg

So the chip shown in the article looks like a typical SMD balun, it is a type of transformer used to adapt impedance between two transmission line. It’s designed to replace a series a lumped element (capacitor, inductors, resistors) normally used for impedance adaptation (in a T or Pi network). The most common used for the device is directly between an antenna an a RF front-end to serve as an antenna tuner.

Technically you could embed and power an RF front-end inside a “flavored” balun to intercept or alter any communication passing through that front-end or even use the antenna to communicate during the down time. So this literally would hack Wifi / Bluetooth at low level and inject code and at the same time create a mesh network of malicious devices to relay information. Welcome to IoT Cyberwarfare.

But this clever hack is probably not limited to RF and is likely to also be embedded in transformers used for isolating Ethernet lines. Common mode chokes (some SMD chokes also look like the chip they are showing) or even some integrated ESD protection solution would be an ideal target as they are inserted in series of the signal.