It would be really nice if there was a way to configure a key command in ST2 to run a specific script depending on the language you're writing.
I don't usually write C unless I'm writing stuff for Arduinos. The Arduino IDE isn't very nice, but they have the magical commands "Control+U" and "Control+Shift+U" that upload code either through the FTDI board or a programmer. If I had that in ST2, I would be in heaven (right now I write in ST2, copy, paste into Arduino IDE, then upload).
I don't usually write C unless I'm writing stuff for Arduinos. The Arduino IDE isn't very nice, but they have the magical commands "Control+U" and "Control+Shift+U" that upload code either through the FTDI board or a programmer. If I had that in ST2, I would be in heaven (right now I write in ST2, copy, paste into Arduino IDE, then upload).