Consider water-soluble resin, but always use 99% IPA to wash. First, dab with tissue paper to soak up drips, wash in used/dirty IPA, and then wash again in clean IPA. This will remove most if not all uncured resin. You should be able to hit within 0.1mm repeatability with anti-aliasing turned off.
Finally, the UVA cure chamber must be able to kick off the resin. After 15min on each side, then wash the build with a hand cleaner. Place all PPE like gloves in a clear bag, and leave in the sun on both sides for 1 hour.
"USD700" is almost double what a mid-sized Creality printer costs, and aftermarket 3M flex plate kits are about $30.
Without a garage/outdoor/lab work-space people shouldn't buy stinky resin printers. =3
Finally, the UVA cure chamber must be able to kick off the resin. After 15min on each side, then wash the build with a hand cleaner. Place all PPE like gloves in a clear bag, and leave in the sun on both sides for 1 hour.
"USD700" is almost double what a mid-sized Creality printer costs, and aftermarket 3M flex plate kits are about $30.
Without a garage/outdoor/lab work-space people shouldn't buy stinky resin printers. =3