So I'm pretty skeptical about this as well (see my other comment on this), but the particular failure mode you're discussing is not what's happening in reality.
> Anyone who has ever cleaned blobs of filament off of a nozzle after a print failure can tell you what happens when you try to pump hot filament into empty space. Filament cools below the melt temperature quickly, especially when it comes into contact with your print.
That's completely irrelevant because this isn't printing into empty space at all. This is injecting molten plastic into confined channels, with no active cooling, made from material that doesn't conduct heat well. You're saying that the plastic will cool too quickly, but I believe the opposite will be true.
The problem that the author is describing is that the plastic is actually far too hot when injected and causes wall collapse. This is because the author isn't taking into account that FDM walls don't handle the required pressure near/above glass-transition points.
The failure mode you're describing is the complete opposite. If you were correct, it would result in cold plugs or extruder jams. It wouldn't result in wall collapse or layer delamination.
> Anyone who has ever cleaned blobs of filament off of a nozzle after a print failure can tell you what happens when you try to pump hot filament into empty space. Filament cools below the melt temperature quickly, especially when it comes into contact with your print.
That's completely irrelevant because this isn't printing into empty space at all. This is injecting molten plastic into confined channels, with no active cooling, made from material that doesn't conduct heat well. You're saying that the plastic will cool too quickly, but I believe the opposite will be true.
The problem that the author is describing is that the plastic is actually far too hot when injected and causes wall collapse. This is because the author isn't taking into account that FDM walls don't handle the required pressure near/above glass-transition points.
The failure mode you're describing is the complete opposite. If you were correct, it would result in cold plugs or extruder jams. It wouldn't result in wall collapse or layer delamination.