Is there any guidance on improving the Core One chamber? I would like to add some thermal insulation around the chamber, but I'm not sure if the firmware will properly detect unexpected thermal insulation in problematic scenario's, if it blindly assumes its a stock Core One... the more you modify a printer, the more it operates in terra incognita.
Could too much thermal insulation cause the bed temperature to lower (to avoid overheating chamber temp) to the point the print no longer adheres? etc.
If you could recommend some articles on the subject I would highly appreciate it.
Could too much thermal insulation cause the bed temperature to lower (to avoid overheating chamber temp) to the point the print no longer adheres? etc.
If you could recommend some articles on the subject I would highly appreciate it.