I too have repurposed a similar machine to try to help me solve a nagging problem.
One of my vehicles uses a hydraulic clutch. By design, air bubbles can be trapped in the master cylinder due to factory bends in the lines and the orientation of the master cylinder when it is properly installed. If this happens it will be impossible to shift the gears (manual transmission) until the air is bled from the lines.
I tried multiple air burping procedures without success. Part of the procedure involves tapping on the hydraulic lines to help dislodge air bubbles so they can flow up and out of the lines into the fluid reservoir. The area is tight and in order to do this efficiently you must remove the master cylinder from the vehicle.
I decided to avoid that removal step and employ a Sharper Image back massager as a tool to dislodge air bubbles with the system in place in the vehicle. Since that massager is huge it would not fit into tight places under the hood so I used a length of PVC pipe held tight to the lines to transfer the vibration to the lines. This allowed me to get large air bubbles out of the lines. In the end I was not able to remove enough air using this hack because an O-ring near the bottom of the system is missing or bad and that allows air to enter and flow up so i could vibrate that thing all day and never get anywhere. It was a shot in the dark anyway. If that O-ring were not missing or bad I know it would work.
One of my vehicles uses a hydraulic clutch. By design, air bubbles can be trapped in the master cylinder due to factory bends in the lines and the orientation of the master cylinder when it is properly installed. If this happens it will be impossible to shift the gears (manual transmission) until the air is bled from the lines.
I tried multiple air burping procedures without success. Part of the procedure involves tapping on the hydraulic lines to help dislodge air bubbles so they can flow up and out of the lines into the fluid reservoir. The area is tight and in order to do this efficiently you must remove the master cylinder from the vehicle.
I decided to avoid that removal step and employ a Sharper Image back massager as a tool to dislodge air bubbles with the system in place in the vehicle. Since that massager is huge it would not fit into tight places under the hood so I used a length of PVC pipe held tight to the lines to transfer the vibration to the lines. This allowed me to get large air bubbles out of the lines. In the end I was not able to remove enough air using this hack because an O-ring near the bottom of the system is missing or bad and that allows air to enter and flow up so i could vibrate that thing all day and never get anywhere. It was a shot in the dark anyway. If that O-ring were not missing or bad I know it would work.