I made a silverware holder custom-fit to my silverware.
I found a half-inch thick HDPE cutting board at a restaurant supply store, cut it to fit my drawer, then drilled holes in it and inserted short wooden dowels to hold the stacks of silverware in place. To position the dowels, I wrapped a nail in tape to match the diameter of the dowels, then placed my silverware on the board, slid the nail up next to it, and gave it a tap to mark the board where the holes needed to be drilled.
It worked really well and was quite easy to do. I highly recommend it.
I found a half-inch thick HDPE cutting board at a restaurant supply store, cut it to fit my drawer, then drilled holes in it and inserted short wooden dowels to hold the stacks of silverware in place. To position the dowels, I wrapped a nail in tape to match the diameter of the dowels, then placed my silverware on the board, slid the nail up next to it, and gave it a tap to mark the board where the holes needed to be drilled.
It worked really well and was quite easy to do. I highly recommend it.