• Knock off the first 30 seconds of your 'interior shots' video where the machine is presumably registering itself. I don't much care about that :)
• Show the resultant printed film from the side on somewhere, so we can see how thin it is. From first glance, I got the impression the output was quite thick, whereas apparently it's only 16 microns (taken from your spec sheet). It might seem obvious to you, but it wasn't here and I think would be much more impressive.
Neat tech, I've forwarded it to someone who might have use for it.
• Knock off the first 30 seconds of your 'interior shots' video where the machine is presumably registering itself. I don't much care about that :)
• Show the resultant printed film from the side on somewhere, so we can see how thin it is. From first glance, I got the impression the output was quite thick, whereas apparently it's only 16 microns (taken from your spec sheet). It might seem obvious to you, but it wasn't here and I think would be much more impressive.
Neat tech, I've forwarded it to someone who might have use for it.
Good luck!