I assume that this has cost advantages over machining. The feature sizes are quite unimpressive:
>Minimum hole sizes depending on stock thickness
>Try to avoid designing too small holes as it might be impossible for the laser to cut through. Keep a note of the following:
1.0mm minimum hole diameter: 3.5mm
1.5mm minimum hole diameter: 4.0mm
2.0mm minimum hole diameter: 5.0mm
3.0mm minimum hole diameter: 6.5mm
>Minimum hole sizes depending on stock thickness
>Try to avoid designing too small holes as it might be impossible for the laser to cut through. Keep a note of the following: 1.0mm minimum hole diameter: 3.5mm 1.5mm minimum hole diameter: 4.0mm 2.0mm minimum hole diameter: 5.0mm 3.0mm minimum hole diameter: 6.5mm